Dropping a match, an iron, or even forgetting to switch off your hair straightener can leave burn marks on your carpet. But how do you get rid of these stains?
In this write-up, we are glad to let you know that you don’t need to start saving money to get a new carpet just yet. Because with our help, you can learn how to remove burns from carpet in just a few easy steps.
In this article, we will be providing you with all the necessary information you need on how to fix burnt carpet. If you have this challenge, keep on reading, and you will have the necessary solutions on how to repair carpet burns.
How to Remove Minor Burns from Carpet
Table of Contents
You can follow the steps below for burns that are not too large, such as those burns that could have been caused by mistakenly dropping a cigarette on the carpet.
What will be needed
Scissors, sandpaper, cleaning solution (one-part hydrogen peroxide to ten parts water), vacuum, water spray bottle, tweezers, paper, hefty book, wide-tooth comb, carpet cement
Instructions in Detail
- With the sandpaper, sand away the burn mark.
- Remove any debris using a vacuum.
- With your scissors, cut away any leftover charred fibers.
- If the burn mark persists, soak a towel in your cleaning solution. With a paper towel, blot the stain. Begin on the outskirts and make your way inward.
- Using water, mist the area and blot dry.
- Allow to air dry thoroughly. If the minor burn mark is no longer visible, you may be able to stop here. Keep reading if you need to patch up the hole.
- Pull some strands from a different part of the carpet with the tweezers. We recommend putting the carpet underneath a couch, bed, or table where it won’t be seen.
- Gather sufficient fuzz to cover the hole left by your little burn.
- To make the hole, spread the carpet fuzz in the shape of the hole.
- Add decent quality carpet cement to the hole. The carpet fuzz should be pushed into the cement.
- Place a thick book on top of the paper.
- Patiently wait for a couple of hours of drying time.
- Finally, remove the jammed paper and book from the room. Scrub the carpet fluff into the area affected carefully with a wide-tooth comb.
How to Remove Large Burns from a Carpet
If you have a more significant burn, such as one caused by a lump of fallen coal, you will need to replace the carpet.
What will be needed
Paper, heavy book, scissors, utility knife, vacuum, wide-tooth comb, and matching carpet scrap (which you can buy from your carpet retailer
Instructions in Detail
- Remove any debris using a vacuum.
- With your scissors, cut away any leftover charred fibers.
- If the burn mark persists, soak a towel in your cleaning solution. Using a paper towel, blot the stain. Begin on the outskirts and make your way inward.
- Using water, mist the area and blot dry.
- Allow to air dry thoroughly. If the minor burn mark is no longer visible, you may be able to stop here. Keep reading if you need to patch up the hole, though.
- Grab some strands from a separate part of the carpet with the tweezers. We suggest putting the carpet underneath a couch, bed, or table where it won’t be seen. Gather enough fuzz to cover the hole left by your little burn.
- To make the hole, spread the carpet fuzz in the shape of the hole.
- Apply good quality carpet cement to the hole. The carpet fuzz should be pushed into the cement.
- Place a thick book on top of the paper.
- Patiently wait for a couple of hours of drying time.
- Carefully remove paper and book from the room. Scrub the carpet fluff into the existing area carefully with a wide-tooth comb.
Read: How to patch carpet
How to Remove Scorch Marks from a Carpet
Your hair straightener and iron may leave unsightly scorch marks on your carpet. Before you go out and buy a new carpet, give this strategy a try.
What will be needed
Water, soft cloths or sponges, cleaning solution (one-part hydrogen peroxide, ten parts water), spray bottle with water
Instructions in Detail
- Dip a gentle cloth in the cleaning solution for a few minutes. Blot the stain from the edges to the center.
- Rep till the stain has vanished.
- To remove the stain, sprinkle it with clean water.
- Allow drying fully after blotting with a soft cloth or sponge.
How Much Does a Burned Carpet Repair Cost?
Carpet repair is not a low-cost endeavor. As a result, we always advise caution when using hot instruments near your carpet. On average, carpet repairs cost between $200 and $300. (1).
Carpet patches range in price from $100 to $200 per piece. If you have a severe carpet burn, this is likely what will be suggested. Defected carpets can cost anywhere from $100 to $250 per square foot to fix.
Additional Advice and Suggestions
Are you already working hard on how to repair carpet burns? Then these pointers may be useful.
- If you’re hesitant or uneasy performing these tasks yourself, you may always hire a carpet professional to do the work for you.
- Make use of a 3 percent version of hydrogen peroxide in your solution. This is the recommended proportion for use in the home. If you go any higher, you risk ruining the carpet.
- You can use a carpet stain remover spray if there is still a trace after snipping the singed portion with scissors.
- If you don’t want to take the carpet up and fix it, you can certainly attempt fabric paint over it.
Related: How to fix cigarette burns in carpet
In conclusion
All the procedures we have provided on how to repair carpet burns are very easy and straightforward; if you are ready to fix those burns, start implementing, and you won’t regret it.
This article was written to help you understand every detail about how to fix burnt carpet and to help you make an informed decision when faced with the fixing one.
We hope you found it helpful; if you did, kindly share it across your entire social media pages.